Bentek Systems - SCADA and Telemetry Solutions
Bentek Systems
SCADA & Telemetry Solutions


SCADA           
LINK


Home

Products

Services

Applications

Technotes

Support

Contact Us

SCADA Applications - Oil & Gas

WATER/CO2 INJECTION WELL SCADA MONITORING SYSTEM

The SCADALink 900-MB RTU / radiomodem can be used to implement a cost effective Injection Well SCADA monitoring system. Bentek Systems provided the Injection Well SCADA system shown below.

 scadaappoilinject1.gif (5188 bytes)

sl900mbhand.JPG (16015 bytes)With capabilities for analog inputs, digital inputs and pulse inputs,  SCADALink 900-MB RTU / radiomodem can be used to:
                     - measure flow rate
                     - measure annulus and casing
                        pressure
                     - perform flow totalization

 

injectionwell1.JPG (9212 bytes)SCADALink 900-MB's were used to implement a cost effective, wireless SCADA system for Injection Well monitoring:

- water disposal well
- water/CO2 injection for enhanced recovery

 


In this application, the host polled the remote 900-MB I/O via Modbus RTU protocol. By using the 900-MB's integrated Modbus compatible I/O, no additional RTU or PLC equipment was required at the remote site. Analog and digital inputs from the Injection Well transmitters were connected directly to the 900-MB's I/O interface and polled by the host. Additionally, the 900-MB's low power consumption allowed for a low cost remote solar power installation.

For the quickest solution, Bentek Systems integrates the SCADALink 900-MB into its SCADALink SOLAR: a complete, ready to install Water Injection RTU system which includes:

        - Solar Panel
        - Battery / Regulator
        - License-free radio communications / Modbus compatible RTU
        - Nema 4X Enclosure
        - Antenna, feedline and lightning arrestor

Bentek Systems		 Bentek Systems
SCADA & Telemetry Solutions

504 - 42nd Ave.S.E.
Calgary, Alberta, Canada T2G   1Y6
(403)  243-5135  Fax: (403) 243-5165
www.scadalink.com